AQUAPURA SPLIT

EFFICIENCY & QUALITY OPERATING PRINCIPLE There is a cooling liquid that is pumped to an outdoor heat exchan- ger (evaporator). Here the liquid, with the help of a fan, absorbs the energy from the atmosphere to the temperature differential obtai- ned outdoors. During this process, the liquid changes to a gaseous state. The gaseous state is sucked in by the mechanical part of the system, the compressor. Here it is compressed, the pressure goes up and consequently the liquid temperature increases. After this, the liquid travels to a second inside heat exchanger (condenser) and transfers heat to the water in the cylinder. The fluid goes into liquid state by cooling down. The liquid pressure is reduced due to a stran- gulation that happens in the expansion valve and the process starts again. Cylinder Condenser (Coil) Ceramic Resistance + Thermostat + Sensor Magnesium Anode (if applicable) High Density Insulation Split Cover Electronic Controller Ventilator Evaporator Expansion Valve Unit box Compressor 1 2 3 4 5 6 7 8 9 10 11 12 5 7 4 6 11 12 3 1 2 8 9 10 ENERGIE.PT WALL HANGING DHW HEAT PUMP • Stainless Steel Cylinder • Domestic Hot Water at 65 0 C in Heat Pump mode • Possible to fit in standard cabinet 600 × 600 mm • 160 liters capacity • Absolute silence in the interior of the house • Hot Water in less than 3 hours • Up to 20m between indoor and outdoor unit • Up to 75% real savings • Condenser outside the tank W A R R A N T Y C Y L I N D E R 5 YEARS See warranty conditions PORTUGUESE MANUFACTURING